Reference Receiver Sensitivity Setup
Receiver Sensitivity Setup
To set up the equipment for Receiver Sensitivity test, follow the proced ura l steps (see page 83) in the
application.
Inrush setup
To set up the equipment for Inrush test, follow these steps:
1. Use the dongle on the Inrush section of the test fixture to connect it to the host system.
2. Connect the current probe between the V
BUS
loop wire on the Inrush section on the Test fixture and
Ch1 of the oscilloscope.
3. Select the measurement and select the
command
button to run the application.
198 TDSUSB2 Universal Serial Bus Measurements Package
To Next Page
Loading...
Need help?
General
