TOHATSU 2 Stroke Cylinder Series User Manual

SECTION 2
2-24
1-/ 2-Cylinder
PERIODIC INSPECTI0NS
NOTE
It is recommended that a complete engine overhaul
be performed after 300 operating hours.
ltem Inspection
Before
Each
Use
After
1st 10
Hours
2 Days
Every
30 Hrs
or
7 Days
Every
50 Hrs
or
30 Days
Every
100 Hrs
or
60 Days
Remarks
Fastener
torque
Check the following:
• Cylinder head bolts
• Cylinder head cover
bolts
• Exhaust cover bolts
• Carburetor
mounting bolts
• Intake manifold
bolts
• Crankcase bolts
• Flywheel nut
• Starter motor
installation bolts
(where applicable)
• Driveshaft housing
bolts
• Gearcase bolts
• Propeller shaft
housing bolts
• Propeller nut
• Lower engine cover
mounting bolts
• Engine mounting
bolts
••Torque to
specification.
Gearcase • Check oil level and
add oil as required.
• Check for water
or metallic matter
in gear oil.
• See Lubrication
Chart in this
section.
Spark
Plugs
• Check plug gap.
• Remove carbon
deposits.
••Replace plugs when
electrodes are
worn.
Carbure-
tors
• Disassemble and
clean.
• Check float valve
for wear.
• Replace worn parts
as required.
Fuel Tank,
Pick-up
Tube,
Filters,
and Fuel
Pump
• Disassemble, clean,
and inspect.
• Check for leakage.
• Check for cracks.
••
Fuel and
Recircula-
tion Hoses
• Clean and inspect
• Check all hose
clips.
• Replace hoses
every 2 years.

TOHATSU 2 Stroke Cylinder Series Specifications

General

Brand	TOHATSU
Model	2 Stroke Cylinder Series
Category	Outboard Motor
Language	English