SECTION 1
1-2
1-/ 2-Cylinder
WARNING
Inadequate knowledge of safe shop practices can
result in severe injury or death. Review general
safety procedures and specific safety information
provided for each procedure prior to beginning
any repairs.
INTRODUCTION
Marine manufacturers are required to comply with special regulations
and standards to ensure their products are safe and reliable for the
consumer. As the marine technician, it is your responsibility to keep
these products safe when performing normal rigging, repair and
maintenance operations.
It is not possible to foresee all safety hazards which may occur or
to include all the knowledge of an experienced technician in a
single service manual. Therefore, it is assumed that those using this
manual have a working knowledge of 2-cycle outboard engines and the
proper technical training for servicing them.
This section discusses safe shop practices and general safety
concerns relevant to the operations performed throughout this
manual. Read this section carefully and follow all safety statements in
this manual as they pertain to the procedures at hand. Remember,
always use common sense when servicing outboard engines!
SAFETY STATEMENTS
The following safety statements are found throughout this manual
and indicate information which, if ignored, could result in safety
hazards or faulty service techniques:
DANGER
Indicates the presence of a hazard which, if ignored,
WILL result in severe injury or death.
WARNING
Indicates the presence of a hazard which, if ignored,
COULD result in severe injury or death.
CAUTION
Indicates the presence of a hazard which, if ignored,
COULD result in minor personal injury or damage
to product, equipment, or other property.
NOTE
Indicates special information to facilitate the installation,
operation, or maintenance of the product or further
clarify information which is important but not hazard
related.
KC-5030
To Next Page
Loading...
Need help?
General
