4.17 Optical disk drive 4 Replacement Procedures
4.17.2 Ejecting the optical disk
CAUTION: The following procedure is emergency cope only when the optical disk inside
ODD (here, refers DVD super multi drive to DVD) can not be ejected
because of some failure.
Disassembling the ODD drive assembly
The following describes the procedure for ejecting the optical disk from the optical disk drive
(See Figure 4-27).
1. Remove the following screws securing the ODD cover.
• M1.8×2C S-THIN HEAD screw ×4
2. Open the ODD cover in the direction of the arrow to remove it from the ODD base
assembly.
3. Hold the optical disk and lift it out.
M1.8x2C S-THIN HEAD
Hook
ODD cover
Optical disk
M1.8x2C S-THIN HEAD
ODD base assembly
Figure 4-27 Ejecting the optical disk
QOSMIO G30 Maintenance Manual (960-546) [CONFIDENTIAL] 4-45
To Next Page
Loading...
Need help?
General