26
General Information
ABS Disable (models with
ABS only)
It is possible to temporarily disable the ABS
system. The ABS system cannot be
permanently disabled, it will be enabled
when the ignition is turned off and then on
again.
To Disable the ABS
To access the ABS Disable function, turn the
ignition to the ON position.
Press and release button 'A' until set up is
visible in the display screen then press
button 'B'.
Press and release button 'A' until ABS is
visible.
Pressing button 'B' will disable the ABS
system; the message ABS OFF will be
displayed for 2 seconds, and the ABS
warning light will be illuminated.
To Enable the ABS
To enable the ABS system again, turn the
ignition off and on.
Service Interval Indicator
1. Service indicator
2. Remaining distance
When the ignition is switched on and the
distance to the next service is 500 miles
(800 km) or less, the service symbol will be
displayed for 3 seconds and the clock will
show the distance remaining before the next
service.
When the remaining distance is 0 miles
(0 km) the service symbol will remain on until
the service has been carried out and the
system has been reset by your authorised
Triumph dealer. If the service is overdue, the
distance will be displayed as a negative
number.
If the ABS is disabled, the brake system will
function as a non-ABS braking system. In
this situation braking too hard will cause
the wheels to lock, and may result in loss of
control and an accident.
To Next Page
Loading...
Need help?
General
