UNI-T UTD1025CL User Manual

UTD1000L User Manual
58
Notes:
Nouns explanation
Normal mode:
Peak value test mode:
Average mode:
1. Select acquisition mode to observe single
signal
2. Select peak value test mode to observe
envelop of signal to avoid confusion
3. Select average acquisition mode to reduce
random noise in the displayed signal and the
average value frequency shall step in with
multiples of 2 setting average frequency
selection from 2 to 256
oscilloscope collects signal to
reconstruct waveform with equal time interval
under the acquisition
mode oscilloscope shall find out the maximum
and minimum value of input signal in each
acquisition intervals and to display waveform by
those values Thus oscilloscope can acquire
and display narrow pulse or those narrow pulses
will be leaked under the acquisition mode and
noise seems louder
under the mode, oscilloscope will
acquire several waveforms to calculate average
value and display waveform finally thus
reducing random noise
Press key DISPLAY to enter into display menu, as
shown in the following picture:
.
.
,
.
.
,
.,
“”
.
,,
.
Display Set
Picture 6-14 Waveform Display Set

UNI-T UTD1025CL Specifications

General

Brand	UNI-T
Model	UTD1025CL
Category	Test Equipment
Language	English