General Safety Overview
The apparatus is strictly designed and produced
under the GB4793 Safety Requirements for
Electronic Measuring Apparatus and IEC61010-
1Safety Standard. The apparatus meets the over
voltage standard CAT V and safety
standards for pollution level II
Please read the following safety prevention
measures to prevent personal injury and any
damage to the product or other products connected
with the product. To avoid any possible danger, the
product shall be applicable in the stitulated
scope and be repaired by the specially trained
personnel.
To use the voltage probe, test lead wire and
adapter with certain insulation attached with the
oscilloscope or use the accessories designated by
UNI-T applicable to oscilloscope apparatus
series product.
Before using, check if any mechanic damage to
the multimeter test pen, oscilloscope probe and
accessories and please replace it if any damage
were found.
To remove all unused test pen, probe an
accessories.
To insert adapter into the AC socket and connect
it with the oscilloscope
In measurement in the CAT ambient don t
connect the voltage higher than 300V with the
oscilloscope input port and don t connect the
voltage higher than 600V with the multimeter input
port in the CAT ambient
Ⅲ 600
.
.
:
.
Ⅲ,'
'
Ⅲ.
Warning: to prevent electric shocking or fire,
please use the dedicated adapter approved to
apply in the country
Warning: if the oscilloscope input port were
connected with the voltage higher than 42 V 30
Vrms),to avoid electric shocking please
(
●
●
●
●
●
UTD1000L User Manual
2
To Next Page
Loading...
Need help?
General
