UTD1000L User Manual
71
8. Press left right key to select storage position
as 1
9 Press key F3 to callback, Load Success
indicated on screen means callback successful and
waveform shall appear on screen
10. Press key F4 to close reference waveform.
To callback waveform under the following steps:
1. Press key SHIFT and character shift will
appear on the right upper corner of screen
2. Press key to enter into cursor set menu
3. Press key F3 to select cursor measurement
type
There are two cursor measurement types in cursor
measurement menu: voltage and time.
In measuring voltage, you can use key SELECT
on board and up down left right key to adjust
cursor position respectively it means to
measure if select time you can measure
Voltage/time measurement method: when cursor
1or 2 appear at the same time adjust cursor
position with the up down left right key and
press key SELECT to select cursor Reading
displayed shall be voltage or time value between
the two cursors.
If cursor function is open, measurement value shall
appear automatically on the left upper corner of
screen
/
;
.
;
;
;
;
///
,
,, .
,
///
.
.
Cursor Measurement
ΔV Δt
Picture 6-28 Time Cursor Measurement Menu
To Next Page
Loading...
Need help?
General
