120 Appendix
Cleaning the handset
Removing everyday dirt
To clean the handset and the charging shell, simply wipe them with a damp or anti-static cloth.
Never use a dry cloth.
Do not use abrasive cleaning agents.
After contact with liquids
1. Deactivate the handset immediately. Do NOT activate it!
2. Remove the batteries immediately. Leave the battery compartment open.
3. Allow the liquid to drain off:
– Hold the handset in a horizontal position with the open battery compartment facing down.
– Hold the handset in a vertical position with the open battery compartment facing down.
Shake the handset gently, slightly tilting it back and forth.
– Dab all components dry and then leave the handset in a warm spot (other than a microwave,
oven, etc...) for at least 72 hours with open battery compartment and keypad facing down.
When it has fully dried out, you will usually be able to use it again.
Storage
To avoid damage, the handset should not be stored with sharp objects, such as knives or tools,
etc. We recommend using a protective pouch
Page 123.
The following appears:
Not possible
or:
Incorrect entry.
or:
Key not programmed.
Speed-dial number not availab-
le, appointment entered incor-
rectly, entry blocked or not allo-
wed, prerequisite not fulfilled
(for
example if there is no se-
cond partner for toggling), num-
ber dialled was incomplete.
Correct your input, select a per-
mitted option, enter the phone
number in full
.
The following appears:
no access
Blocked function was called. Apply to the relevant service per-
sonnel for the COS for the blo-
cked function.
The following appears:
PIN incorrect
Incorrect PIN was entered. Enter the correct PIN.
The following appears:
not available
Phone number was not fully en-
tered, the star or hash key was
not pressed.
Enter the phone number correct-
ly or as prescribed.
The following appears:
protected
Data transfer is active. Wait and try again later.
Error Possible cause Remedy
To Next Page
Loading...
Need help?
General
