50 Conducting calls – enhanced functions
Call charge display
After a call has ended, the display shows the connection charges for the current
call as standard. If the costs are to be displayed continuously during an outgoing
call, this function must be requested from the carrier.
You can check and display the call charges for your phone number as a total for
a period that can be set by the service engineer.
First the call charges for the last charged call are displayed. The total call charg-
es are displayed after five seconds.
This function can also be called directly by entering the code Page 107.
c or d Press and hold the Talk or Speakerphone key.
Open the system menu.
> < [ Select the menu item and confirm.
> < [ Select the menu item and confirm.
a Press the On-hook key to end the operation.
Call tracing
You can apply to your carrier for "call tracing" on malicious calls. An authorised
extension is then in a position to request the identification of the phone number.
This also works for 30 seconds after the malicious caller has hung up. However,
you should not hang up.
This function can also be called by entering the code Page 107.
p You receive a malicious call.
Do not hang up.
Open the system menu.
> < [ Select the menu item and confirm.
> < [ Select the menu item and confirm. The caller is identified in the attendant con-
sole.
a Press the On-hook key to end the operation.
If a call is transferred, the costs are assigned to the telephone to which
the call was transferred from this point onwards.
To Next Page
Loading...
Need help?
General
