engine speed may be increased without driving the
boat; (warm-up mode).
The drive is disengaged.
Drive engaged for movement ahead/astern.
Single lever
When the single-lever function is activated, the lever
that is moved from its position first becomes the control
lever for both engines. The other control lever has no
function as long as the single-lever function is
activated.
In order to activate the single-lever function, the control
levers must in be roughly the same position, max 10%
difference.
Cruise control panel
Switch on cruise control by pressing the
button.
Make fine adjustments to the locked engine speed by
pressing the + or – buttons to increase or reduce the
speed.
Docking Panel
When the boat is operated from a docking station,
engines can be stopped and started and messages
can be managed using the docking panel.
The joystick can be used for maneuvering when the
docking station is activated; refer to the Instruments
and Controls, page 54 section for further information.
Activation
Activate the helm station by depressing the on/off
button. Further pressure on the button locks the helm
station.
To switch off the function, hold the button down for 3
seconds.
Twin installation
Both engines in a twin installation must be running
before the docking station can be activated.
The helm station is inactive.
The helm station is active and the docking
function is switched on.
The helm station is locked.
Instruments and Controls
26 47712786 11-2022 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
