Cruise Control
The Cruise Control function can be based on either
rpm or speed, setting is done in respective display
settings menu. Default setting is rpm.
1 Activate the function by pressing the button (1) on
the control. The button lights up and a beep
acknowledge the activation.
Fine-tuning the locked engine speed/rpm,
increasing (+) or reducing (-), can be done with the
button (2) at the back side of the control or in the
cruise control panel.
2 Deactivate the function by pushing the button on
the control or move the control lever.
The function can be reactivated by pressing the +/-
button.
Rpm based
Fine-tuning with +/- button is made in steps of 2% for
each step.
If the function is reactivated it will ramp up (or down)
until it reaches .....
Speed based
Unit for Cruise Control speed can be set to Kts, Mph or
Km/h.
Always make sure to have a stable speed before
activating the function. The speed has to be at least 3
knots for the function to be activated.
The target speed is shown in the display. When fine-
tuning with the +/- button the speed is adjusted to next
even 0.5 knots, 0.5 Mph or 1 km/h.
Features
47712786 11-2022 © AB VOLVO PENTA 63
To Next Page
Loading...
Need help?
General
