Volvo Penta MD22 User Manual

115
Flywheel, flywheel cover
12
Install the flywheel and the drive adapter for the re-
verse gear, operation 21A-01. Check that the guide
pins are correctly installed in the housing. Install
the adapter housing for the reverse gear and tighten
the mounting screws to 43 Nm. Check the concen-
tricity of the housing (C) and the axial run-out (D) in
the same way as in points 5 and 7 above. Install the
support plate for the manifold.
13
Install the starter motor, operation 22B-01. Install
the drive components from the rear of the engine.

Volvo Penta MD22 Specifications

General

Engine Type	Diesel
Number of Cylinders	4
Type	In-line
Compression Ratio	22:1
Fuel System	Indirect injection
Displacement	2.0 L
Bore	84 mm
Cooling System	Freshwater cooled