73
Engine settings
8
Check the fuel injection pump adjustment, opera-
tions 17A-03.
9
Remove the adjustment drifts and turn the engine
two revolutions to ensure that there is nothing pre-
venting free movement.
10
Install the cap of the timing cover, operation 12A-01
and install the screw in the adjustment hole in the
camshaft cover.
11
Connect the battery.
Injection timing, checking/ad-
justment (17A-03)
Special tools: 884955, 885139 (TMD22P, TAMD22),
885037
1
Position the piston in cylinder 1 at TDC in the com-
pression stroke, operation 17A-01. Remove the ad-
justment drifts.
2
Remove the plug and the washer from the center of
the fuel injection pump rear plate and install the
gauge. Set the gauge so that it reads approximately
3.0 mm. Ensure that there is sufficient play between
the gauge and the oil filler pipe, to allow for any ra-
dial movement in the pump.
3
Turn the crankshaft slowly (counter-clockwise seen
from the front of the engine) until the gauge displays
the pump element at the bottom of the stroke. Set
the gauge to zero.
4
Slowly turn the crankshaft clockwise, until the ad-
justment drift goes into the adjustment hole in the
flywheel. In this position the gauge should indicate
the correct lift height for the pump element, see
Workshop Manual “Technical Data”.
To Next Page
Loading...
Need help?
General
