2-6 BA DT08 SL EN – Edition 1.0 * * dt08b210.fm
Safety instructions
Applications with lifting gear
Definition:
Applications with lifting gear are understood as procedures involving raising, transporting
and lowering loads with the help of slings and load-securing devices (e.g. ropes, chains).
In doing so, the help of persons is necessary for securing and detaching the load. This
applies for example to lifting and lowering pipes, shaft rings or containers.
• No applications with lifting gear!
Trailers
• Hitching and towing other vehicles is not allowed!
Transport
• The machine must be loaded and transported only in accordance with the Operator’s
Manual!
• For towing the machine observe the prescribed transport position, admissible speed
and itinerary.
• Use only suitable means of transport of adequate capacity/payload!
• Safely secure the machine on means of transport! Use suitable mounting points and
load-securing devices
• The recommissioning procedure must be strictly in accordance with the Operator’s
Manual!
Temperature ranges
The machine can be used at a maximum temperature of +45 °C and a minimum tempera-
ture of −15 °C. Get in touch with your Wacker Neuson dealer if you intend to use the
machine in other temperature ranges (e. g. tropical temperatures, etc.).
Carry out all maintenance and inspection work before storing the machine for the winter.
Then store the machine in a dry place at ambient temperature (about +15 °C). Observe
these temperature ranges so as not to affect the machine’s service life.
To Next Page
Loading...
Need help?
General
