BA DT08 SL EN – Edition 1.0 * dt08b510.fm 5-1
Maintenance
5 Maintenance
5.1 Introduction
Operational readiness and the service life of machines are heavily dependent on mainte-
nance.
It is therefore in the interest of the machine owner to carry out the prescribed maintenance
work.
Before carrying out service and maintenance work, always read, understand and follow
the instructions given in:
• Chapter 2 “Safety instructions” of this Operator’s Manual and
• The Operator’s Manuals of the attachments.
Daily service and maintenance work, and maintenance according to maintenance plan
“A” must be carried out by a specifically trained driver. All other maintenance work must
be carried out by trained and qualified staff only.
The maintenance plans indicate when the maintenance work mentioned below must be
carried out.
Maintenance strut
Careful when carrying out maintenance work on or under the skip, and in
general when carrying out maintenance work with the dumper body dumped
out –
Danger of accidents!
☞ Use the maintenance strut
Mount the maintenance strut as follows:
☞ Take maintenance strut A out of its bracket
☞ The maintenance strut is fastened with lock pin C and pin D
☞ Fit maintenance strut A onto tilt ram B
☞ Secure maintenance strut A with lock pin C and pin D
During transport fit maintenance strut A as shown in Fig. 66 – transport bracket.
Fig. 66: Maintenance strut
Fig. 66: Transport bracket
A
B
D
C
A
To Next Page
Loading...
Need help?
General
