Wacker Neuson DT08-D User Manual

5-14 BA DT08 SL EN – Edition 1.0 * * dt08b520.fm
Maintenance
Checking the hydraulic oil level
Proceed as follows:
☞ Park the machine on level ground
☞ Raise the skip and lock it in the safety position See Maintenance strut on page 5-1.
☞ Stop the engine
☞ The dipstick is integrated in filler cap B of hydraulic oil tank A
☞ Check whether the oil level is between MIN and MAX
☞ Fill up hydraulic oil if the oil level is too low
Filling up hydraulic oil
Refill hydraulic oil only with the engine stopped otherwise hydraulic oil will overflow at the
filler opening on the hydraulic oil tank.
Fill up as follows:
☞ Park the machine on level ground
☞ Raise the skip and lock it in the safety position See Maintenance strut on page 5-1.
☞ Stop the engine
☞ Unscrew filler cap B
☞ Use an oil funnel with microfilter to fill in oil
With the filter insert in place:
☞ Fill up hydraulic oil
☞ Check the hydraulic oil level with the dipstick integrated in filler cap B
☞ Fill up if necessary and check again
☞ Firmly tighten filler cap B by hand.
Fig. 81: Hydraulic oil level
A
B
Fig. 82: Hydraulic oil level
FULL
LOW

Wacker Neuson DT08-D Specifications

General

Brand	Wacker Neuson
Model	DT08-D
Category	Construction Equipment
Language	English