Wacker Neuson DT08-D User Manual

BA DT08 SL EN – Edition 1.0 * dt08b210.fm 2-9
Safety instructions
2.8 Warning of special hazards
Electrical energy
• Use only original fuses with the specified current rating!
Switch off the machine immediately and rectify the malfunction if trouble occurs in the
electrical system!
• When working with the machine, maintain a safe distance from overhead electric lines!
If work must be carried out close to overhead lines, the equipment/attachments must be
kept well away from them. Caution, danger! Get informed on the prescribed safety
distances!
• If your machine comes into contact with a live wire
• Warn others against approaching and touching the machine
• Have the live wire de-energised
• Do not leave the machine until the line that has been touched or damaged has been
safely de-energised!
• Work on the electrical system may only be carried out by a technician with appropriate
training, in accordance with the applicable electrical engineering rules
• Inspect and check the electric equipment of the machine at regular intervals. Defects
such as loose connections or scorched cables must be rectified immediately
• Observe the machine’s operating voltage!
• Always remove the earthing strap from the battery when working on the electrical
system or when carrying out welding work!
• Starting with a battery jumper cable can be dangerous if carried out improperly.
Observe the safety instructions regarding the battery!
Gas, dust, steam, smoke
• Operate the machine only on adequately ventilated premises! Before starting the
internal combustion engine on enclosed premises, ensure that there is sufficient venti-
lation!
Observe the regulations in force at the respective site!
• Welding, burning and grinding work on the machine may only be carried out by a
Wacker Neuson dealer. Risk of fire and explosion!
• Before carrying out welding, flame-cutting and grinding work, clean the machine and its
surroundings from dust and other inflammable substances, and ensure that the
premises are adequately ventilated – danger of explosions!
• In areas with special hazards (e.g. toxic gases, caustic vapours, toxic environments),
wear appropriate protective equipment (breathing filters, protective clothing)!
Hydraulics
• Work on the hydraulic equipment of the machine must be carried out only by persons
having specific technical knowledge and experience in hydraulic systems!
• Check all lines, hoses and screw connections regularly for leaks and obvious damage!
Repair any damage and leaks immediately! Splashed oil can cause injury and fire
• In accordance with the Operator’s Manual/instructions for the respective assembly,
release the pressure in all system sections and pressure lines (hydraulic system) to be
opened before carrying out any implementing/repair work!
• Hydraulic and compressed-air lines must be laid and fitted properly! Ensure that no
connections are interchanged! The fittings, lengths and quality of the hoses must
comply with the technical requirements

Wacker Neuson DT08-D Specifications

General

Brand	Wacker Neuson
Model	DT08-D
Category	Construction Equipment
Language	English