3-20 BA DT08 SL EN – Edition 1.0 * * dt08b330.fm
Operation
Crane handling the machine
Safety instructions
• The crane and the lifting gear must have suitable dimensions
• Crane handling the machine requires suitable lifting gear
• Secure the machine against unintentional movement!
Incorrect crane handling of the machine –
Danger of accidents!
☞ Ensure that no-one is near the machine!
☞ Have loads fastened and crane operators guided by experienced persons
only! The person guiding the crane operator must be within sight or sound
of him
☞ Ensure that the crane and the lifting gear (cables, chains) have sufficient
load-bearing capacity!
☞ Only raise the machine with an empty loader unit and skip
☞ Stay clear of suspended loads!
☞ It is essential that you read the safety instructions at the beginning of this
chapter and follow any other safety instructions relevant in your country!
☞ Load the machine as follows:
• Empty the skip and the loader unit
• Lower the skip
• Stop the engine
• Remove the ignition key.
• Use suitable lifting gear, chains etc.
☞ Length L1 of the lifting gear on the skip must be at least 2.0 m long
☞ Length L2 of the lifting gear (two cables or chains) on the control stand must be at
least 2.0 m long
• Slowly raise the machine
Fig. 53: Craning operation
L1
L2
L2
L1
L2
To Next Page
Loading...
Need help?
General
