Maintenance E 2200, E 3000ES
100 wc_tx001670gb.fm
7.7 Replacing the Fuel Filter
Requirements
Machine shut down
New fuel filter element and gasket kit
Removal
NOTICE: Do not remove the fuel filter assembly from the machine unless the filter
housing cap needs to be replaced.
To remove the fuel filter element, carry out the following procedure.
Note: In the interests of environmental protection, place a plastic sheet and a con-
tainer under the machine to collect any liquid which drains off. Dispose of this liquid
in accordance with local environmental protection laws.
1. Disconnect the fuel line at the quick-connect fitting (a).
2. Loosen (do not remove at this time) the bolt (b) that secures the filter housing
cap (c).
3. Hold the filter housing (g) and lightly tap the bolt (b) with a hammer to break the
seal between the gasket (e) and the housing (g).
4. Remove the bolt (b) and gasket (d).
5. Remove the filter housing cap (c) and gasket (e).
6. Pull the fuel filter element (f) out of the housing.
Installation
Perform the procedure below to install the new fuel filter.
1. Remove any remaining gasket material from the filter housing cap or the
housing.
2. Place the new fuel filter element (f), with exposed screen portion facing up, into
the housing (g).
3. Place the new gasket (e) on the top lip of the housing.
4. Slide the new gasket (d) on the bolt (b).
5. Reinstall the filter housing cap (c) to the housing (g) with bolt (b).
6. Reconnect the fuel line at the quick-connect fitting (a).
Result
The fuel filter has now been changed.
wc_gr008078
To Next Page
Loading...
Need help?
General
