Wacker Neuson E 2200 User Manual

Maintenance E 2200, E 3000ES
96 wc_tx001670gb.fm
7.5 Filling the HTF Reservoir
Requirements  Genuine Wacker Neuson Heat Transfer Fluid
 Machine is on a level surface
NOTICE: Use only factory-recommended Heat Transfer Fluid (HTF). Failure to
comply may damage the machine.
Background The procedure for routine filling of the HTF reservoir differs slightly from that when
a low level fault is encountered. If your machine has experienced a low level fault,
see topic Resetting a Low HTF Level Fault.
Fill the HTF
reservoir
1. Remove the pin and move the fill valve (3) to the OPEN position.
2. Move the operation valve (2) to the CLOSED position.
3. Remove the fill hose from its storage location under the hose reel. Remove the
cap from the hose if a cap is provided.
4. Place the open end of the fill hose into a container of HTF.
This procedure continues on the next page.
wc_gr007807
2
3
3
2

Wacker Neuson E 2200 Specifications

General

Brand	Wacker Neuson
Model	E 2200
Category	Heater
Language	English