BA 1404 en – Edition 2.7 * 1404b340.fm 3-71
Operation
Installing a bucket
• Install a bucket only if it is positioned on level ground with the flat side facing
downward
• Apply grease to the pins and joints before inserting the pins
• Starts the engine
• Straighten the stick so that bores D and E are flush
• Insert greased pin F
• Actuate the stick cylinder until bores H and I are flush
• Insert the greased pin J
• Install linch pins K
Quickhitch (option)
The attachment must always be safely locked onto the quickhitch –
Accident hazard!
☞ Before starting work, ensure that the attachment is securely locked onto the
quickhitch by means of the lock mechanism. You must be able to see the
lock on either side of the mounting bore of the attachment.
☞ Re-equip as follows:
• Approach the machine to the attachment
• Pick up the bucket with coupling bar M and coupling claws L of the quickhitch
• Engage lock mechanism N into mounting bore O
• Place the bucket on level ground
☞ Lock as follows:
• Stop the engine
• Insert tube P (included in scope of delivery) in clamping sleeve Q
• Press the tube downward
• The lock pins must be in position R
☞ Unlock as follows:
• Stop the engine
• Insert tube P (included in scope of delivery) in clamping sleeve Q
• Press the tube upward
• The lock pins must be in position S
Abb. 143:Installing a bucket
D
H
I
E
F
K
K
J
Abb. 144: Bucket with quickhitch
O
L
M
N
P
Abb. 145: Bucket with quickhitch
Q
S
R
To Next Page
Loading...
Need help?
General
