BA 1404 en – Edition 2.7 * 1404b510.fm 5-1
Maintenance
5 Maintenance
5.1 Introduction
Operational readiness and the service life of machines are heavily dependent on mainte-
nance.
It is therefore in the interest of the machine owner to perform the mandatory maintenance
Bear in mind the following points before performing servicing and maintenance:
• Chapter 2 “SAFETY INSTRUCTIONS” of this Operator’s Manual
• The Operator’s Manuals of the attachments.
Perform the prescribed inspections and rectify any disorders before putting the machine
into operation.
Secure the open engine cover and other open covers appropriately. Do not open the
engine cover and other covers on slopes or in strong wind.
When using compressed air, dirt and debris can be blown into your face. Therefore, wear
safety glasses, protective masks and clothing when using compressed air.
Daily servicing and maintenance, and maintenance according to maintenance plan “A”
must be performed by a specifically trained operator. All other maintenance must be per-
formed by trained and qualified personnel only.
The maintenance plans indicate when the maintenance mentioned below must be per-
formed – see Maintenance plan (overview) on page 5-38.
Immediately repair or replace parts that are already damaged or not working properly
before they are due for replacement.
Safety-relevant parts may only be repaired or replaced by a Wacker Neuson
dealer or a Wacker Neuson service center.
Parts Interval
Hydraulic hoses Replace hydraulic hoses every 6 years from
the date of manufacture, even if they do not
seem to be damaged.
Seat belt No replacement necessary. Replace the seat
belt after an accident.
To Next Page
Loading...
Need help?
General
