3-32 BA 1404 en – Edition 2.7 * * 1404b330.fm
Operation
Heating adjustment
Adjust the temperature inside the cab as follows:
• Cooling:
☞ Turn heater valve 15 toward A until you reach the required temperature.
• Heating:
☞ Turn heater valve 15 toward B until you reach the required temperature.
In order to reach the required temperature quickly, we recommend performing only
small changes of the setting on control valve 1, otherwise it takes some time for
the air in the cab to reach the required temperature.
3.16 Washer system
Do not actuate the washer system with the front window folded up. Do not actuate the
washer system if the reservoir is empty, otherwise this can damage the electric pump.
Tank for washer system
The tank filler inlet is located at the rear left in the cab.
Add only clean faucet water!
Add a suitable cleaning agent if required.
In winter: add antifreeze for washer systems to the water.
Refer to the antifreeze instructions for further information on concentrations.
Abb. 81: Heating adjustment
A
15
B
Abb. 82: Front wiper switch (symbolic representation)
1
2
43
Front window wiper
On ☞ Press rocker switch 43 downwards ➥ Front wiper is on
Off ☞Press rocker switch 43 upwards ➥ Front wiper returns to base position
1st
speed
☞ Press rocket switch 43 in the 1st.
position (down)
➥ Front wiper is on
2nd
speed
☞ Press rocker switch 43 in the 2nd.
position (down)
➥ Pump sprays washer water on the
window
Abb. 83: Tank for washer system
To Next Page
Loading...
Need help?
General
