2-6 BA 1404 en – Edition 2.7 * * 1404b210.fm
Safety instructions
• When working in buildings or in enclosed areas, look out for in particular:
• Height of the ceiling/clearances
• Width of entrances
• Maximum load of ceilings and floors
• Sufficient room ventilation – poisoning hazard!
• Avoid any operation that might be a risk to machine stability!
• During operation on slopes, move or work uphill or downhill. If performing machine
travel across a slope cannot be avoided, bear in mind the tilting limit of the machine!
Always keep the attachments/work equipment close to the ground. This also applies to
downhill machine travel!
During machine travel across a slope, the load must be on the uphill side of the
machine.
• On sloping terrain always adapt the travel speed to the prevailing ground conditions!
Never change the travel speed on, but before a slope.
• Before leaving the operator seat always secure the machine against unintentional
movement and unauthorized use!
Lower the attachments to the ground.
• Before starting work check whether
• all safety devices are properly installed and functional.
• Before starting machine travel or before taking up work:
• Ensure that visibility is sufficient
• Adjust your correct seat position, never adjust the operator seat during machine
travel or operation!
• Fastening the seat belt
• Inspect the immediate area (children!)
• On the job site the operator is responsible for third parties!
• Caution when handling fuel – increased fire hazard!
• Ensure that fuel does not come into contact with hot parts!
Do not smoke during refueling, and avoid fire and sparks. Stop the engine during
refueling and do not smoke!
• Never get on or off a moving machine! Never jump off the machine!
• Should the lights of the machine not be sufficient for performing work safely, provide
additional lighting of the job site.
• Empty the bucket before driving on public roads.
• Installed work lights must not be switched on for travel on public roads. They can be
switched on in work operation if motorists are not blinded.
• The accelerator pedals take time getting used to them. Travel speed must be adapted
to your skills and to the prevailing conditions.
To Next Page
Loading...
Need help?
General
