BA 1404 en – Edition 2.7 * 1404b330.fm 3-35
Operation
Seat belt 14 is for the safety of the driver during work on the construction site as well as
during road travel.
Fastening the seat belt:
☞ Seat belt 14 is to be fastened before each drive as follows:
• Hold belt on buckle latch A and run it slowly and steadily over the hips to buckle B
• Insert buckle latch A into buckle B with an audible click (pull test)
• Tighten the seat belt by pulling at its end
➥The seat belt must always be tightly in place over the hips!
Unfastening the seat belt:
☞ Safety belt 14 to be removed as follows:
• Hold the seat belt
• Press red switch C on buckle B
➥Latch A is released from buckle B by spring pressure
• Slowly return the seat belt to the retractor
Longer/shorter seat belt adjustment:
☞ Lengthen the seat belt as follows:
• Hold buckle latch A at a right angle to the seat belt and pull the seat belt to the
required length
• To shorten the seat belt, just pull the free end D of the belt
Abb. 88: Fastening the seat belt
14
B
A
Abb. 89: Unfastening the seat belt
14
B
A
C
Abb. 90: Longer/shorter seat belt adjustment
A
D
To Next Page
Loading...
Need help?
General
