Xerox D110 System Administration Guide

Allocate Memory
For each interface, you can select the memory capacity for the receiving buffer
(temporary storage for data sent from the client). You can change the receiving buffer
capacity depending on the pattern of use and purpose. Increasing the receiving buffer
capacity may allow a client to be released sooner from an interface.
Tip
If you change the memory capacity settings, the memory is reset, and therefore data
stored in all memory areas is lost.
Note
It is not possible to assign more than the total memory. When the power is turned on,
if the settings exceed the available memory capacity, they are automatically adjusted
by the system.
1. From the System Settings screen, select Print Service Settings and select Allocate
Memory.
2. Select the item to be set or changed, and select Change Settings.
3. Select the desired value for that item.
4. Select Save.
Note
When a port is set to Disabled, the corresponding items that are associated with that
port do not appear.
Note
Depending on the amount of data sent from the client, increasing the memory
capacity may not change the amount of time that it takes to release the client.
PostScript Memory
Specify the memory capacity used for PostScript. Set a value from 8.00-96.00 MB, in
0.25 MB increments.
HP-GL/2 Auto Layout Memory
Specify the memory capacity used for HP-GL/2. Set a value from 64-5120 KB, in 32 KB
increments.
Note
The maximum value that can be set for both the PostScript Memory and HP-GL/2 Auto
Layout Memory options vary according to the available memory capacity.
Receiving Buffer - USB
Select a value from 64 KB through 1024 KB.
Xerox
®
D95/D110/D125/D136 Copier/Printer10-52
System Administration Guide
System Settings

Xerox D110 Specifications

General

Brand	Xerox
Model	D110
Category	Printer
Language	English