To Next Page

To Previous Page

2.5 Print After Checking Printing Result - Sample Print 31

2.5 Print After Checking Printing Result -

Sample Print

When at least 256 MB of memory are added, you can use the sample print feature.

Note

• The data stored in the RAM disk is erased when the printer is switched off.

About Sample Print

Sample Print is a feature that allows you to store the print data of multiple copies in the

memory, print out only the first set to check the print result and if satisfactory, print the

remaining copies from the control panel.

Note

• Sample print data that has become redundant can be deleted using the control panel. For details, refer

to “At the Control Panel” (P. 33).

• To delete all sample print data that has become redundant, refer to “RAM Disk” (P. 73).

Configuring Sample Print

The procedure to configure Sample Print using the PCL printer driver is as follows.

First of all, carry out the sample print settings at the computer and send data to the printer

for printing. Then, carry out the output procedure at the printer to output the print data.

At the Computer

This section explains the procedure using WordPad on Windows XP as an example.

Note

• The way to display the printer properties dialog box differs according to the application software. Refer to

the manual of your respective application software.

1. From the [File] menu, select [Print].

2. Select this printer as the printer to be used and click [Preferences].

3. On the [Paper/Output] tab, specify at least 2 for [Copies].

Send

data

Store in

printer

Print only one document

If result is

not OK

Stop printing using the

control panel

Print out remaining sets

using the control panel

Xerox DocuPrint C2100 User Manual

Other manuals for Xerox DocuPrint C2100