Scanning
104 WorkCentre 3045 Multifunction Printer
User Guide
Loading Documents for Scanning
Position the original document as shown.
Document Glass
Lift the automatic document feeder or the
document glass cover, then place the
original face down in the upper left corner
of the document glass.
Automatic Document Feeder
Insert originals face up with the top of the page
entering the feeder first. Adjust the paper guides so
they fit against the originals.
Automatic Document Feeder Guidelines
Note: Available on WorkCentre 3045NI Multifunction Printer only.
The automatic document feeder accommodates the following originals:
• Width: 148–216 mm (4.1–8.5 in.)
• Length: 210–355.6 mm (8.3–14 in.)
• Weight: 60–105 g/m² (16–28 lb. Bond)
Follow these guidelines when loading originals into the automatic document feeder:
• Load originals face up so that the top of the document enters the feeder first.
• Place only loose sheets of paper in the automatic document feeder.
• Adjust the paper guides so that they fit against the originals.
• Insert paper in the automatic document feeder only when ink on the paper is dry.
• Do not load originals above the MAX fill line.
Document Glass Guidelines
The document glass accommodates original sizes up to 216 x 297 mm (8.5 x 11.7 in.). Use the document
glass rather than the automatic document feeder to copy or scan the following types of originals:
• Paper with paper clips or staples attached