Xerox WorkCentre 5016 User Manual

System Settings
Xerox WorkCentre 5016/5020 User Guide 123
System Settings
The following procedure describes how to configure the system settings.
If the machine is in the No Account Mode
1) Proceed to Step 1 of the following procedure.
If the machine is in the Single Account Mode
1) Refer to "Logging in to the Machine" (P.68) to log in to the machine.
2) Proceed to Step 1 of the following procedure.
If the machine is in the Multiple Account Mode
1) Refer to "Logging in to the Machine" (P.69) to log in to the machine under the
System Administrator’s account.
2) Proceed to Step 1 of the following procedure.
1. Hold down the <Log In/Out> button for
four second.
The machine enters the System Setting
Mode.
The letter [P] appears blinking in the
Display.
2. Enter a menu number that you wish to configure using the numeric keypad in
reference to "System Setting List" (P.124).
3. Press the <Start> button to confirm the entered menu number.
The currently set value of the menu number appears blinking in the Display.
4. Enter a new value using the numeric keypad in reference to "System Setting List"
(P.124).
Note • Automatically erases the previously set value in the Display as you start entering a new
value.
<Log In/Out>
button
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 5016 Specifications

General

Brand	Xerox
Model	WorkCentre 5016
Category	All in One Printer
Language	English