Xilinx ZCU111 User Manual

ZCU111 Board User Guide 18
UG1271 (v1.1) August 6, 2018 www.xilinx.com
Chapter 2: Board Setup and Configuration
Off: U93 bridge enabled
12 J164 U111 MPS430 RST_B and test pin options 32
1-2: MSP430_RST_B connected to PMOD1_0 Open
2-3: MSP430_TEST connected to PMOD1_1 Open
13 J29 SFP0 J29 enable jumper On 38
On: SFP0 TX_DISABLE = GND = enabled
Off: SFP0 TX_DISABLE = high = disabled
14 J35 SFP1 J35 enable jumper On 38
On: SFP1 TX_DISABLE = GND = enabled
Off: SFP1 TX_DISABLE = high = disabled
15 J40 SFP2 J40 enable jumper On 38
On: SFP2 TX_DISABLE = GND = enabled
Off: SFP2 TX_DISABLE = high = disabled
16 J44 SFP3 J44 enable jumper On 38
On: SFP3 TX_DISABLE = GND = enabled
Off: SFP3 TX_DISABLE = high = disabled
17 J87 USB2ANY cable select jumper Off 66
On: USBANY_SDO connected to I2CSPI_SDO
Off: USBANY_SDO not connected to I2CSPI_SDO
18 J89 ZU28DR RFSoC U1 ADC bank 224 ADC_REXT select Off 9
On: bank 224 ADC_REXT pin AB8 = GND
Off: bank 224 ADC_REXT pin AB8 = 2.49K to GND
19 J90 ZU28DR RFSoC U1 DAC bank 228 DAC_REXT select Off 10
On: bank 228 DAC_REXT pin W8 = GND
Off: bank 228 DAC_REXT pin W8 = 2.49K to GND
20 J101 SPI CS select header 66
1-2:
3-4:
5-6:
7-8:
21 J111 SPI SDO select header 66
1-2:
3-4:
5-6:
Table 2-2: Default Jumper Settings (Cont’d)
Callout
Number
Ref Des Function Default
Schematic
Page
Send Feedback

Xilinx ZCU111 Specifications

General

Brand	Xilinx
Model	ZCU111
Category	Motherboard
Language	English