ZCU111 Board User Guide 8
UG1271 (v1.1) August 6, 2018 www.xilinx.com
Chapter 1: Introduction
°
Micro SD card
°
USB-to-JTAG bridge
•Clocks
°
GTR_REF_CLK_DP 27 MHz
°
GTR_REF_CLK_USB3 26 MHz
°
GTR_REF_CLK_SATA 125 MHz
°
CLK_100 100 MHz
°
CLK_125 125 MHz
°
PS_REF_CLK 33.33 MHz
°
USER_MGT_SI570 (default 156.25 MHz)
°
USER_SI570 (default 300 MHz)
• PS DDR4 4 GB 64-bit SODIMM
• PL DDR4 4 GB 64-bit component (4x16-bit)
• PS GTR (bank 505) assignment
°
DisplayPort 1.2 transmit only (two GTR)
°
USB3 (one GTR)
°
SATA with M2 connector (one GTR)
• PL GTY assignment (16 total)
°
SFP28 (four, bank GTY128)
°
FMCP HSCP DP (four, bank GTY129)
°
FMCP HSCP DP (four, bank GTY130)
°
FMCP HSCP DP (four, bank GTY131)
• PL FMCP HSCP (FMC+) connectivity - full LA[00:33] bus
• PS MIO connectivity
°
PS MIO[0:5, 7:12]: dual Quad SPI flash memory
°
PS MIO[13]: PS_GPIO2
°
PS MIO[14:17]: two channels of I2C
°
PS MIO[18:19]: UART (one of three FT4232 UART channels)
°
PS MIO[22:23]: PS_PB, PS_LED I/F
°
PS MIO[26]: platform management unit (PMU)
°
PS MIO[27:30]: DisplayPort control
To Next Page
Loading...
Need help?
General
