2. Servo driver and motor installation
2-1.Servo driver installation
2-1-1.Installation site
Please install it in the installation cabinet without sunshine or rain.
Do not use this product near corrosive and flammable gas environments such as hydrogen sulfide,
chlorine, ammonia, sulfur, chlorinated gas, acid, alkali, salt, etc.
Do not install in high temperature, humidity, dust, metal dust environment.
No vibration place.
2-1-2.Environment condition
Item Description
Use ambient
temperature
-10~40℃
Use ambient
humidity
-20~90%RH (no condensation)
Storage temperature -20~60℃
Storage humidity -20~90%RH (no condensation)
Vibration resistance ≤ 4.9m/s
2
Altitude
No more than 1000m, please derate to use when it is higher than 1000m (derate
1% for every 100m high)
2-1-3.Installation standard
Be sure to comply with the installation standard in the control cabinet shown in the figure below. This standard
is applicable to the situation where multiple servo drivers are installed side by side in the control cabinet
(hereinafter referred to as "when installed side by side").
14
To Next Page
Loading...
Need help?
General
