4. Before using operation of servo system
4-1. Operate panel display and operate introduction
button Operation
STA/ESC Short press: state switch, state return
INC
Short Press: The display data increases
Long press: The display data increases
continuously
DEC
Short Press: The display data decreases
Long press: The display data decreases
continuously
ENTER
Short press: shift;
Long press: Set and view parameters.
Note: after power on, the panel will conduct self-test operation, and all display nixie tubes and five
decimal points will light up for 1 second at the same time.
By switching the basic state of the panel operator, the operation state display, parameter setting, auxiliary
function operation command and other operations can be carried out.
After pressing the STA / ESC key, the States will be switched in the order shown in the figure below.
Status: BB indicates that the servo system is idle; Run indicates that the servo system is running and RST
indicates that the servo needs to be powered on again.
Parametric setting Px-xx: The first X represents the group number, and the last two X represents
the parameter serial number under the group.
Monitor status Ux-xx: The first X represents the group number, and the last two X represents the
45
To Next Page
Loading...
Need help?
General
