Page 100 FTDX5000 OPERATING MANUAL
CONVENIENT MEMORY FUNCTIONS
The FTDX5000 contains ninety-nine regular memories, labeled “01” through “99”; nine specialy programmed limit memory
pairs, labeled “P1L/P1U” through “P9L/P9U”; and five QMB (Quick Memory Bank) memories, labeled “C-1” through
“C-5”. Each memory location not only stores the VFO-A frequency and mode, but also stores the various settings shown
below. By default the 99 regular memories are contained in one group. However, they can be arranged in up to six separate
groups, if desired.
QUICK POINT:
The FTDX5000’s memory channels store the following data (in addition to the operating frequency):
Frequency
Mode
Clarifier status and its Offset Frequency
ANT status
ATT status
IPO status
VRF status
Roofing filter status and its Bandwidth
Noise Blanker status
CONTOUR status and its Peak Frequency
DSP Noise Reduction (DNR) status and its Reduction algorithm selection.
DSP Notch filter (NOTCH) status
NAR bandwidth status
DSP Auto Notch filter (DNF) status
Repeater Shift Direction and CTCSS Tone Frequency
MEMORY OPERATION
IMPOTANT NOTE
On rare occasions the stored data may become cor-
rupted by miss operation, or static electricity. When
repairs are made, the memory data may be lost.
Please write down or record the memory informa-
tion so you will be able to restore it if needed.
To Next Page
Loading...
Need help?
General
