Yaesu FTdx5000MP User Manual

Page 114 FTDX5000 OPERATING MANUAL
You may connect an after-market transverter to the rear panel TRV jack. The output frequency is selectable from 14, 28,
and 50 MHz, and the output level is approximately –10 dBm (0.1 mW) at 50 Ohms.
SETUP
A BOUT THE T RANSVERTER O UTPUT T ERMINAL
1. Press the
[
MENU
]
button briefly to enter the Menu
mode.
2. Rotate the
(
VFO-A
)[
SELECT
]
knob to select Menu
item “150 TUNE MY BAND”.
3. Rotate the
(
VFO-B
)[
SELECT
]
knob to select the de-
sired input frequency band of the transverter in menu
item (T14M OFF, T28M OFF, or T50M OFF ).
4. Press the
[
ENT
]
button (one of the
[
BAND
]
buttons)
to change the parameter to “ON” (the “OFF” notation
will change to “ON”).
5. Rotate the
(
VFO-A
)[
SELECT
]
knob to select Menu
item “172 TGEN ETX-GND”.
6. Rotate the
(
VFO-B
)[
SELECT
]
knob to set this Menu
item to “ENABLE” to enable the internal relay con-
nected to the rear panel TX GND jack.
7. Press and hold the
[
MENU
]
button for at least two sec-
onds to save the new setting, and exit to normal opera-
tion.
Setting the Transverter Frequency Offset
You may set up the frequency display so that it shows the
frequencies of the transverter operating band (instead of
the 28 MHz band frequencies used as the “IF” on your
FTDX5000).
Example: Setting up the FTDX5000 display for use with a
144 MHz Transverter
1. Connect the 144 MHz transverter to the FTDX5000.
2. Press the
[
MENU
]
button briefly, to enter the Menu
mode.
3. Rotate the
(
VFO-A
)[
SELECT
]
knob to select the
Menu item which designates the input frequency band
from the transverter (040 GENE TRV 14M, 041
GENE TRV 28M, or 042 GENE TRV 50M).
4. Rotate the
(
VFO-B
)[
SELECT
]
knob to select
“44MHz” on the display.
5. Press and hold the
[
MENU
]
button in for at least two
seconds to save the new setting and exit.
The “100 MHz” digit of the frequency is not displayed,
so when you are operating on 2 meters and see “45
MHz” on the frequency readout, this indicates “145
MHz” instead.
ADVICE:
With the setup described above, tuning the actual operat-
ing range of the FTDX5000 will correspond to transverter
operating frequency of 144-145 MHz, with “44-45” being
displayed on the front panel of the transceiver.
(
VFO-B
)[
SELECT
]
Knob
[
MENU
]
Button
(
VFO-A
)[
SELECT
]
Knob
[
ENT
]
Button

Yaesu FTdx5000MP Specifications

General

Brand	Yaesu
Model	FTdx5000MP
Category	Transceiver
Language	English