104
Changing the Effects
The send level is the amount of signal being sent to the DSP for
processing. It is set for each individual drum pad.
1
Select the Send Level display page by pressing the [ PAGE+ ] or [ PAGE– ]
button. The current level flashes under the “SNDLVL” prompt.
2
Press the pad you want to modify.
3
Set the send level by rotating the Jog Dial or by using the [ +1 ] and [ –1 ]
buttons.
The range is from “0” to “7”.
A level of “7” is the maximum signal level and a level of “0” sends no signal
to the DSP.
■ Send Level
HINT
You can also select another drum kit or pad by changing the focus area with the
[ > ] cursor button, then selecting a drum kit or pad by rotating the Jog Dial or by
using the
[ +1 ] and [ –1 ] buttons.
NOTE
You can change the Send Level for the individual pads of the preset drum kits.
Your altered settings will stay in effect until you select another drum kit.
PAGE – PAGE +
PATTERN EFFECT
A CHASE
DRUM KIT
PAD
MAIN A
PAD BANK
OTHERS
HH
SD
BD
To Next Page
Loading...
Need help?
General
