108
Changing the Effects
In this mode, you can adjust the right and left channel delays.
1
Select the Delay Time display page by pressing the [ PAGE+ ] or [ PAGE– ]
button. The current levels are displayed under the “D.TIME” prompt with
the left channel level flashing.
2
Set the left channel delay time by rotating the Jog Dial or by using the
[ +1 ] and [ –1 ] buttons.
For the delays “DELY1” and “DELY2”, the range is “00” to “99”. These
settings change the length of the delay loop for each channel. A low value
sets a short loop while a high value sets a long loop.
The other two delays, “DELY3” and “DELY4”, use synchronized delays:
3
Change the focus to the right channel delay time by pressing the [ > ]
cursor button. Set its value by rotating the Jog Dial or by using the [ +1 ]
and [ –1 ] buttons.
■ Delay Time
NOTE
As with feedback gain, the delay time setting can only be applied to the delay
effects. When the reverberation effects are selected, “
-- --” is displayed.
T0 Sets a 32nd note triplet delay.
T1 Sets a 32nd note delay.
T2 Sets a 16th note triplet delay.
T3 Sets a 16th note delay.
T4 Sets an eighth note triplet delay.
T5 Sets an eighth note delay.
PAGE – PAGE +
PATTERN EFFECT
A CHASE
DRUM KIT
MAIN A
PAD BANK
OTHERS
HH
SD
BD
3
3
3
To Next Page
Loading...
Need help?
General
