Drive Ready Signal .............................................................67
4. START-UP PROGRAMMING & OPERATION ............ 69
4.1 Section Safety.................................................................. 70
4.2 Using the Digital LED Operator........................................ 73
Keys, Displays, and LEDs.....................................................73
Digital Text Display .............................................................74
LED Screen Displays...........................................................75
LO/RE LED and RUN LED Indications ....................................75
Menu Structure for Digital LED Operator..................................77
4.3 The Drive and Programming Modes ................................ 78
Navigating the Drive and Programming Modes..........................78
Changing Parameter Settings or Values ..................................82
Verifying Parameter Changes: Verify Menu ..............................83
Switching Between LOCAL and REMOTE................................84
Parameters Available in the Setup Group.................................85
4.4 Start-up Flowcharts ......................................................... 86
Flowchart: Basic Start-up and Motor Tuning .............................86
4.5 Basic Operation ............................................................... 87
Initialize Parameter Values: A1-03..........................................87
Frequency Reference Source: b1-01.......................................87
Run Command Input Selection: b1-02 .....................................89
Stopping Method Selection: b1-03 ..........................................91
Acceleration/Deceleration: C1-01 to C1-04...............................92
Drive Duty Mode and Carrier Frequency Selection: C6-01 and
C6-02..............................................................................93
Multi-Step Speed Operation (4-Step Speed).............................96
Drive Input Voltage Setting: E1-01..........................................99
V/f Pattern Settings: E1-04 to E1-10 ..................................... 100
Motor Parameters: E2-01 to E2-03 ....................................... 103
Digital Output: H2-01 ......................................................... 103
Analog Outputs: H4-01 to H4-03 .......................................... 104
Motor Protection: L1-01 and L1-02 ....................................... 105
Notes on Controlling the Brake for the Hoist Application............ 108
Drive Status Monitors: U1-01 to U4-13 .................................. 109
4.6 Powering Up the Drive ....................................................111
Powering Up the Drive and Operation Status Display ............... 111
Table of Contents
YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
5
2/6/2008-14:44
To Next Page
Loading...
Need help?
General
