Step Display/Result
4.
Scroll through parameters by pressing the key until C1-01
appears.
5.
Press to view the current setting value (10.0). (Number
farthest to the left flashes)
6.
Press until the desired number is selected. (“1” flashes)
7.
Press the key and enter 0020.0.
8.
Press and the drive will confirm the change.
9. The display automatically returns to the screen shown in Step 4.
10.
Press the key until back at the initial display.
u
Verifying Parameter Changes: Verify Menu
The Verify Menu lists edited parameters from the Programming Mode. The Verify Menu
helps determine which settings have been changed,
and is particularly useful when replacing
a drive. If no settings have been changed the Verify Menu will read
. The Verify menu
also allows users to access and re-edit edited parameters.
Note: The Verify Menu will not display parameters
from the A1 group even if those parameters have been changed
from default settings.
The following example is a continuation of the steps beginning on page 82. Here, parameter
C1-01 is accessed using the Verify Menu and is changed again to 20.0 s.
To check the list of edited parameters:
Step Display/Result
1. Turn on the power to the drive. The initial display appears.
2.
Press until the display shows the “Verify” representation.
3.
Press to enter the list of parameters that have been edited
from their original default settings.
Scroll through the list by pressing the key.
4.
Press the key until C1-01 appears.
4.3 The Drive and Programming Modes
YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
83
4
Start-Up Programming
& Operation
2/6/2008-14:44
To Next Page
Loading...
Need help?
General
