Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
263
Example: Setting a Line Key as Group Pickup Key
The following example shows the configuration for a group pickup key.
Example
linekey.1.type = 23
linekey.1.line =1
linekey.1.value =*98
linekey.1.label =Sell
After provisioning, you can easily press the Group Pickup key (line key 1) to pick up an incoming call to any phone
within a predefined group of phones.
Note: If the “linekey.X.value” is not assigned with a group pickup code, the Park key will invoke the group pickup code set by
“features.pickup.group_pickup_code” or ”account.X.group_pickup_code”.
Example: Setting a Line Key as Forward Key
When the phone receives an incoming call, you can press a Forward key to forward the incoming call to the preset
number.
When the phone is idle, the key behavior depends on the forward modes:
Forward Modes Key Behavior
Phone Mode
The destination number is configured:
Press the Forward key to activate/deactivate the always forward fea-
ture or switch the target among Forward keys.
The destination number is blank:
Press the Forward key to enter the forward setting screen or activ-
ate/deactivate the forward feature (if forward has been configured
from the Call Forward menu).
Custom Mode Press the Forward key to enter the forward setting screen.
The following example shows the configuration for Forward keys.
Scenario Conditions Related Topic
features.fwd.allow = 1
Call Forward
features.fwd_mode = 0
forward.idle_access_always_fwd.enable = 0
Example
######Set a Forward key for Bill######
linekey.1.type = 2
linekey.1.line =1
linekey.1.value =4603
linekey.1.label =Bill
######Set a Forward key for Tom######
linekey.2.type = 2
To Next Page
Loading...
Need help?
General
