Yealink SIP-T2 User Manual

Administrator’s Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
463
LED Status
Description
The monitored user is talking.
Off The monitored user does not exist.
State Monitor for Intercom Contact Configuration
The following table lists the parameters you can use to configure state monitor for intercom contact.
Parameter
features.intercom.led.enable <y0000000000xx>.cfg
Description
It enables or disables the phone to display different intercom DSS key LED status/icons when the
status of monitored user changes.
Note: It works only if “features.intercom.subscribe.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Supported
Devices
All phones except T30P, T30, T19(P) E2 and CP920
Default
0
Parameter
features.intercom.subscribe.enable <y0000000000xx>.cfg
Description
It enables or disables intercom subscription for the phones.
Permitted
Values
0-Disabled
1-Enabled
Default
0
Supported
Devices
All phones except T30P, T30, T19(P) E2 and CP920
Outgoing Intercom Configuration
Yealink phones support two methods for initialing intercom calls.
The following table lists the parameters you can use to configure outgoing intercom.
Parameter
features.intercom.mode <y0000000000xx>.cfg
Description
It configures the intercom mode.
Permitted
Values
0-SIP
1-FAC, the feature access code is configured by “features.intercom.feature_access_code”.
Default
0
Parameter
features.intercom.feature_access_code <y0000000000xx>.cfg
Description
It configures the intercom feature access code.
Note: It works only if “features.intercom.mode” is set to 1 (FAC).
Permitted
Values
String
Default
Blank
Parameter
account.X.call_info
[1]
<MAC>.cfg
Description
It configures the value of the Call-Info header for intercom feature.
The value format likes: <sip:XXX (X can be any value)>; answer-after=0.

Yealink SIP-T2 Specifications

General

Brand	Yealink
Model	SIP-T2
Category	IP Phone
Language	English