17-6
IM WT5000-01EN
17 Saving Numeric Data, Waveform Data, and Screen Images
File Save Conditions
File List (File List)
On the file list, specify the save destination. You can perform file operations such as creating folders on the
storage device, deleting and copying files, and changing file names.
Auto Naming (Auto Naming)
This is the same as the auto naming feature for saving setup data.
File name (File Name)
This is the same as the file name setting for saving setup data.
Comment (Comment)
This is the same as the comment setting for saving setup data.
Saving (Save Exec, EXEC)
Saves the data to the specified save destination with the specified file name.
• It can take anywhere from a few seconds to a few tens of seconds for this instrument to save the data,
depending on the number of waveforms being saved, the data update interval, and the speed to transfer
data to the destination storage device. It will take longer for this instrument to save the data when there many
waveforms are saved or the data update interval is long.
• Measurement stops while this instrument is saving data. After this instrument finishes saving or saving is
cancelled, measurement resumes.
• To save data when the data update interval is 20 s, enable the hold feature, perform a single-shot
measurement, and then save the data after the data update for the single-shot measurement has completed.
Because the header files saved by this instrument use a format that is common to YOKOGAWA measurement
devices, they contain some data that is not used by this instrument.
To Next Page
Loading...
Need help?
General
