18-4
IM WT5000-01EN
Network Drive (Net Drive)
You can save the setup data of this Instrument, numeric data, waveform display data, and screen image data to
a network drive. You can also load the setup data from a network drive into this Instrument.
FTP Server (FTP Server)
Specify the IP address of an FTP server on the network. You can save numeric data, waveform display data, and
screen image data to the server and load setup data from it. In a network with a DNS server, you can specify the
host name and domain name instead of the IP address.
Login Name (Login Name)
Specify the login name.
• Number of characters: Up to 32
• Usable characters: All ASCII characters that are displayed on the keyboard
Password (Password)
Specify the password that corresponds to the login name.
• Number of characters: Up to 32
• Usable characters: All ASCII characters that are displayed on the keyboard
FTP passive Mode (FTP Passive)
Turn FTP passive mode on or off.
In passive mode, the FTP client sets the port number for data transfer. Enable passive mode when you have set
an external FTP server as a network drive or when you are accessing an FTP server through a firewall.
Timeout (Time Out)
If the instrument cannot transfer files for a certain amount of time, it disconnects from the FTP server.
You can set the timeout time to a value between 1 and 3600.
Connecting to the Network Drive(Connect/Disconnect)
When you press Connect, this instrument connects to the specified network drive. When you press Disconnect,
the network drive is disconnected.
18 Ethernet Communication
To Next Page
Loading...
Need help?
General
