Zebra LS2208 Reference Guide

2 - 8 LS2208 Product Reference Guide
Mounting the Stand (optional)
You can attach the base of the scanner’s stand to a flat surface using two screws or double-sided tape (not
provided).
Figure 2-6 Mounting the Stand
Screw Mount
1. Position the assembled base on a flat surface.
2. Screw one #10 wood screw into each screw-mount hole until the base of the stand is secure (see Figure 2-6).
Tape Mount
1. Peel the paper liner off one side of each piece of tape and place the sticky surface over each of the three
rectangular tape holders.
2. Peel the paper liner off the exposed sides of each piece of tape and press the stand on a flat surface until it is
secure (see Figure 2-6).
Two screw-mount holes
Double-sided tape areas
(3 places)
dimensions = 1” x 2”)

Zebra LS2208 Specifications

General

Brand	Zebra
Model	LS2208
Category	Scanner
Language	English