2-2
General Information
Abbreviations and Symbols
Important Repair Information
Replacement Fasteners
Replacement fasteners must be the correct part
number for that application. Use the correct
fastener in the correct location. Fasteners requiring
the use of thread-locking compound are specified
in the repair procedure; refer to the product
manufacturer for proper usage.
One-time Use
Always use new lock nuts, lock washers, crush
washers, cotter pins, and cable ties.
Coatings
Do not use paints, lubricants, or corrosion inhibitors
on fasteners or fastener contact surfaces unless
otherwise specified in the installation procedure
notes. Coatings affect fastener torque and
clamping force, as well as damage the fastener.
Coatings can also affect the operation of electrical
components.
Lifting and Supporting the Motorcycle
CAUTION: DO NOT LIFT THE MOTORCYCLE BY
JACKING UP THE CONTROLLER! DO NOT
SUPPORT THE WEIGHT OF THE MOTORCYCLE
BY SUPPORTING THE CONTROLLER! Doing so,
will damage the controller and other
components.
AC Alternating current
Amp (A) Ampere
AUX Auxiliary
CCelsius
CCM Cellular Connectivity Module
CEL Check Engine Light
cm Centimeter
DC Direct Current
dia. Diameter
DOT Department of Transportation
EPA Environmental Protection
Agency
EV Electric Vehicle
FFahrenheit
FRT Flat Rate Time
HCU Hydraulic Control Unit
HV High Voltage
HW Hardware
lb-ft pounds-feet
in-lb inch-pound
MBB Main Bike Board
mm millimeter
Nm Newton-metre
OAL Overall Length
OBC On-Board Charger
SoC State of Charge
RH Right-Hand
VVolt
WWatt
To Next Page
Loading...
Need help?
General
