Motor and Drive System
Motor 30-1
30
Motor and Drive System
Motor
Motor
Tools Required (includes tools required for
parent jobs):
• T20
• T25
• T30
• T40
• T45
• T50
• 3/16” standard screwdriver
• 2mm hex wrench
• 10mm socket and ratchet
• 13mm socket
• 17mm socket
• 22mm 6-point socket
• 27mm socket
• 13mm wrench
• Non-marring trim removal/pry tool
• Motorcycle stand
• Hoist
• Ratchet straps (x2)
• Scissor jack
New Fasteners Required:
• Cable tie (quantity: 4)
• Double loop cable tie (quantity: 1)
• License plate harness anchor (quantity: 1)
New Seals Required:
• HV cable seals (quantity: 5)
• HV cable O-rings (quantity: 5)
Removal
1. PERFORM LOCKOUT PROCEDURE: See
Lockout Procedure
, page 10.1.
2. Remove high voltage DCDC and CONT fuses.
See High Voltage Fuses
, page 70.1.
3. Unbolt the negative battery terminal eyelet.
Cover eyelet with insulating material. Use
cable tie to secure negative battery wire to the
positive battery cable. See 12 Volt Battery
(Disconnect), page 70.3.
CAUTION: Cover/protect battery terminal
eyelet to reduce the risk of accidentally
contacting the negative battery terminal,
which can inadvertently power up the
12 volt system and damage components.
CAUTION: Secure battery terminal wire to
reduce the risk of arcing and damaging
electrical components.
4. Remove headlight upper fairing. See
Headlight Upper Fairing
, page 60.2.
5. Remove left and right outer side fairings. See
Side Fairings (Outer)
, page 60.14.
To Next Page
Loading...
Need help?
General
