Main tractor's parameters (mm)
Tractor´s weight
Technical data of engines
Note
Turning-circle diameter length
- without ballast weights in front of
cab's grill
3 870
- with ballast weight in front of cab's
grill
4 140
Width over rear fenders 1 840
Height to the mouth of exhaust pipe 2 605
Height of tractor to upper cab's rim 2 615
Clearance height under the girder of
front axle
400
Height of nozzle of multistage
suspension linkage in its topmost
position (the centre of nozzle)
890/840/790/690
Height of swinging draw bar (on
internal bottom fork surface)
418/455
Rear PTO shaft height 725
Wheel base 2 210
Tractor's weight (kg) 3300
Type of tractor Major 60 Major 80
Type of engine TCD 2.9 L4
Design of engine serial, upright, water-cooled
Kind of engine injection, four-stroke with direct fuel
injection, turbocharged engine
Additional flue gas
treatment
Oxidation catalyst (DOC)
Number of rollers 4
Volume of rollers
cm
3
2925
Drilling x heave mm 92x110
Nominal revolutions rpm 2200
Max. speed rpm 2300
Idle run revolutions rpm 900
Injection sequence 1-3-4-2
Compression ratio 1:17,8
Maximum output (EC 24) kW 45 55,4
Specific fuel consumption
2200 rpm
g.kW.h 237,77 229,67
Max. torque / engine
speed
Nm /
rpm
239/1600 300/1600
Minimum oil pressure
(loe idle, engine warm)
MPa 0,14
Max. coolant temperature °C 110
MAIN TECHNICAL PARAMETERS
To Next Page
Loading...
Need help?
General
