Before starting the engine
A check of oil contents in the engine
A check of coolant contents and joint tightness in the cooling system
A check of oil contents in the hydrostatic control circuit tank
A check of oil contents in the transmission and in the final drive
A check of air pressure in all tyres
A check of the tightening of wheels
A check of the state of suspension and connecting devices
After starting the engine
Engine greasing function check (control)
Charging function check (control)
Steering function check (control)
Steering circuit function and tightness check
Efficiency and function of tractor brakes check
Efficiency and function of trailer or semi-trailer brakes check
Steps taken after every 100 hours of operation
A lubrication of the tractor according to the lubrication plan.
A cleaning of cooler plates with compressed air flow.
A check of oil contents in the transmission and final-drive housing.
A check of oil contents in the reducers and in the front driving-axle housing.
A discharge of condensate from the air receiver.
A cleaning and smearing of accumulator battery clips with a thin film of lubricating grease.
A clearing of the raw fuel filter.
Steps taken after every 500 hours of operation
Cogged belt tension check
Hydrostatic steering system clearance check
Pivot of front drive axle clearance check
Clutch and brake pedals adjustment clearance check
Manual clutch function check
Brake function for trailer check
Air pressure system tightness and function check
Driver's seat function check, greasing moving parts with grease
Steps taken beyond 500 Mth interval
with a new tractor or a tractor after general repair
Meter of Mth state 100 500 1000 1500 2000 2500
subsequently after...hours of
operation
Hydrostatic steering hoses
replacement
every 3500 Mth or every
4 years
Foot and manual brake
function check
o o o o o o 500
Front wheels toe-in o 2000
Replacement of the belt of
the accessories drive
3000
Replacement of the
tensioning roller
3000
To Next Page
Loading...
Need help?
General
