Before a drive with the new tractor get to know how to shift gears and try individual positions
of the shifting lever when the engine is stopped.
During normal operation and before you set up, make sure that the technical condition ensures safe
operation of the tractor.
Before you start the engine
Starting the engine
1. Insert the key to the switch box- position '0'.
2. Depress the clutch pedal (start breaker is switched).
3. Shift reversing lever to neutral position (start breaker is switched).
4. Pull manual clutch lever (start breaker is switched).
5. Set the manual fuel control lever to idle run position.
6. Switch the key of switch box from position '0' to position 'I'. Thermostart ignition control lights up. Wait for
the time when ignition control goes out (the time is dependent on the temperature of coolant).
7. As soon as the control goes out (5 s max) turn the key from the position to position 'II' (start).
8. After starting the engine, release the key immediately, it automatically re-turn to position 'I'. Do not start
longer than 15 s.
Before you start the engine, make sure that:
1. tractor is properly braked
2. PTO shaft drive engagement lever is in neutral
osition
3. the main gear shifting lever is in neutral position
If the clutch pedal is not depressed, it is not possible to
start the engine - switch for securing start is not switched.
NM13N050
To Next Page
Loading...
Need help?
General
